Riparazione alimentatore Commodore Amiga 2000
Ho perso troppo tempo per riparare uno solo dei due alimentatori guasti per Amiga 2000, direi che non ha molto senso e non e’ conveniente. Molto meglio sostituire solo il PCB interno dell’alimentatore con uno preso da un qualsiasi alimentatore ATX (di marca decente) per PC riadattando le connessioni del cavo Amiga 2000 al posto di quello utilizzato PC (ATX).
Difetto:
- Morto.
Componenti sostituiti :
- 2 x Diode IN4001
- 1 x Diode Zener 5v1
- 1 x Triac BTB 16 200B (recuperato da un’altro alimentatore)
- 6 x Electrolytic Capacitors.
- 1 x Power supply plug with a filter RIFA inside.
Categorie:Projects / Repairs, Today, Various
can you use that cap meter to measure caps while are soldered on the board?
thx
@xchris
This one: http://www.peakelec.co.uk/acatalog/jz_esr70.html
Ha Ha,
i´m repairing the same PSU.
Short between Ground +12V and +5V.
1 cap had a short
1 cap out of specs
and the BTB 16 200B is death.
wish me luck that that’s all
@MeruG
Hi, do you finally have repaired the Power supply? I have the same with dead BTB..
thank you.
Ciao
Ettore
@ettore
Unfortunately, no. I swapped all the capacitors. The ic swapped. Everything re-soldered. The diodes checked, etc. But the voltage fluctuates extremely with 5 and 12 V line.