Home > Projects / Repairs, Today, Various > Commodore Amiga 2000 Power Supply repair

Commodore Amiga 2000 Power Supply repair

February 16th, 2015 Leave a comment Go to comments

I lost too much time to repair only one of two psu, not convenient. Better to replace only the PCB with a ATX power supply (only the PCB!)

Defect:

  • Dead.

Replaced components:

  • 2 x Diode IN4001
  • 1 x Diode Zener 5v1
  • 1 x Triac BTB 16 200B (recovered from another power supply)
  • 6 x Electrolytic Capacitors.
  • 1 x Power supply plug with a filter RIFA inside.

Categories: Projects / Repairs, Today, Various
  1. xchris
    May 7th, 2015 at 19:00 | #1
    Reply | Quote

    can you use that cap meter to measure caps while are soldered on the board?
    thx

  2. xAD / nIGHTFALL
    May 7th, 2015 at 19:27 | #2
    Reply | Quote
  3. MeruG
    April 5th, 2021 at 10:56 | #3
    Reply | Quote

    Ha Ha,

    i´m repairing the same PSU.
    Short between Ground +12V and +5V.

    1 cap had a short
    1 cap out of specs
    and the BTB 16 200B is death.

    wish me luck that that’s all

  4. ettore
    August 21st, 2021 at 12:12 | #4
    Reply | Quote

    @MeruG
    Hi, do you finally have repaired the Power supply? I have the same with dead BTB..
    thank you.

    Ciao
    Ettore

  5. MeruG
    November 13th, 2021 at 17:50 | #5
    Reply | Quote

    @ettore
    Unfortunately, no. I swapped all the capacitors. The ic swapped. Everything re-soldered. The diodes checked, etc. But the voltage fluctuates extremely with 5 and 12 V line.

CAPTCHA
*