I tried for the first time this circuit to mod the Atari 2600 to have a Composite video output and S-Video instead of RF.

I must say that this modification really amazed me, and i’ve made several others, all very similar for the Atari 2600.

The signal is clean (crystal clear) with both outputs (composite or S-Video), and installation is very simple.

Just place the PCB on the TIA pins (solder side) and solder; no need to remove anything.

I made two different modifications: one with only composite video and the other one with S-Video output as well.

For the version with the composite video output, i always used the same system of installing a 3.5mm female jack in the antenna connector hole (requires removal of the RCA RF plug), everything perfectly secured with a 3D-printed adapter.

For the version with Composite video and SVIDEO output, i used a female mini-DIN, the same one found on the SEGA SATURN.
I soldered the connector’s metal casing to the ground of the RCA RF connector after removing it and also isolated a trace of the RF signal PCB (center RCA pin) that made contact with the metal casing by removing a resistor.

The cable used is the same as the SEGA SATURN; it has dual outputs: RCA AUDIO, RCA COMPOSITE VIDEO, and SVIDEO. I had to cut a strip of about 0.5mm from the plastic casing of the mini-DIN connector to make it fit perfectly in the antenna hole of the Atari 2600 JR.

Gallery with only Composite Video Output:

Gallery with both Composite and Svideo Video Output:

◄12

source: https://retrosix.co.uk/Atari-2600-CleanComp-Composite-Video-Out-p537997297