This sticker can be used for the Commodore 64 case but with the new Ultimate 64 card from Gideon installed.

The archive includes the image in .PSD format (PhotoShop Document) and the fonts.

Generate your own Ultimate64 Badge Online: Ultimate64 badge by Marco Van de Meulenhof

Download: Ultimate 64 PSD Serial Sticker & Fonts (1108)

The Ultimate 64 is a hardware implementation (FPGA) of the entire Commodore 64, and it includes the Ultimate-II+ / LAN / Wi-Fi / HDMi / RGB and many more cool things. An ALL IN ONE solution!

For more information and orders, visit the website.

Ultimate 64 Unboxing:

Ultimate 64 RGB Output Example:

Ultimate 64 RGB Pinout:

Ultimate 64 Manosoft Princess Ultra C64SD 4.0 Test:

Ultimate 64 SIDTap Alternative Audio Output:

Ultimate 64 DigiFIX resistors removed:

source: ultimate64.com

Pioneer LaserActive CLD-A100 – Repair/Recap & Modules full Recap.

Defects:

• The Game cartridges on the Sega Genesis Module do not work but the games on CD-ROM work correctly.
• The INTF Ass’y Interface has some leakage capacitors and in short circuit.
• The PSU has some leakage capacitors and in short circuit.
• Solder joint jumped out on the three connectors that connect the two horizzonal/vertical motherboards.
• Some cold solder on the power stage.

Works that have been done:

• Cleaning and Full Recap PSU.
• Cleaning and Full Recap Sega Genesis/Sega CD PAC-S10 Module.
• Cleaning and Full Recap Nec PC Engine PAC-N1/N1 Module.
• Cleaning and Recap INTF Ass’y Interface.
• Rebuilding PADs of the two pcb connectors.
• Rebuilding cold solder joint on the power stage.

Pioneer LaserActive CLD-A100 Gallery:

123►

Sega Genesis/Sega CD PAC-S10 Module Gallery:

12►

Nec PC Engine PAC-N1/N1 Module Gallery:

ZOE rev 2.0 Inty (Mattel Intellivision) RGB Interface.

Some information about this revision:

• The flat cable that connects the IDC 10+10 male socket to the 10+10 IDC female connector is about 15cm long (in the photo are: 20cm)
• The cable that connects the 7 dupont connectors to the 8-pin DIN female panel socket is 30cm long (in the photo are: 20cm)
• The video cable with a male SCART connector on one end and a 8-pin DIN male on the other side is 2 meters long.
• The audio cable with dupont connector from one end and to solder on the other side is 20cm long.
• The ZOE pcb must be fixed with 3 bioadhesive supports.
• Status LED.
• Improved audio output, there are a little less background noise.

The 8-pole DIN female panel socket can be positioned, after drilling, at any place. I recommend using the RF output hole, removing the RF modulator which is no longer usable after the modification.

This mod like the previous one works ONLY with Mattel Intellivision consoles equipped with the LM1886 (D/A Video Matrix Converter) chips. Example: PAL/SECAM but not UK/NTSC (USA). Better to check, open the console and check.

For console disassembly, desoldering the LM1886 or other connections you can consult the documentation of the previous version.

Gallery:

Soon available for sale.

Alternative closing pins for the Commodore 64 case made with a 3D printer.

I have fixed them with a strong double-sided adhesive tape with a little film of foam.

Gallery: