I have done an accurate cleaning of the leaked battery acid on the mainboard.

I have also replaced the GARY socket destroyed by battery acid and rebuild a pcb track with a wire.

Gallery of the repair:

The problem of the green screen of death is usually due to a problem of DRAM,FAT AGNUS (chip or socket), GARY.

In this case all four DRAMs are failed. The pin 18 (IO/3) was always at high level.

Replacing DRAM everything has started to work properly.

Gallery of the repair:

We begin to explain what is this PHA-2037. This interface/Converter for the Home Computer Texas Instruments TI-99/4a is used to convert the video signals from Component (Y/Pb/Pr) to RGB (Scart Standard).

The defect of the PHA-2037 that i have received for repairing is to display images without the “BLUE” color in this case of the Video Component “Pb”.

The problem was in one of the three LM 318 (Op Amp). Just replaced, the PHA-2037 has begun to work properly.

PS: How you can see from a photo a pin of a transistor has not been cut. Maybe it was better to do it. :D

Gallery of the repair:

Brief summary of NOT repairing the Commodore Chessmate of a dear friend (Giacomo Vernoni).

The Chessmate I received had a funny defect: it worked for 10-15 seconds and then freezed completely with harrowing sounds in the background. So the defect appeared when something warmed up.

Having another Chessmate (mine) to compare the signals to, I noted right away that communication was missing between RIOT (6530) -> ROM (6332) -> CPU (6504) -> RAM (AM9111); CLOCK and RESET were working fine.

I sprayed synthetic ice on the 6530 RIOT to check if the problem was caused by this IC: as a matter of fact, after lowering its temperature, the Chessmate began to work again. I was glad I found the problem, but quite unhappy because the spare part is almost impossible to find. To double check I decided to unsolder the 6530, install a socket, and try it on my Chessmate.

It worked! Damn… after thinking about it for a while, I thought that maybe the spray partially freezed the nearby ROM too.

So I reinstalled the 6530 back in the non-working Chessmate, I turned it on, and after 15 seconds I sprayed the synthetic ice on the 6332, and it magically worked again.

That’s it… from that moment on, the Chessmate always worked! after the freezeing spray I left the Chessmate turned on for two hours and it never stopped working.

So, I’m asking myself: did the ice repair the ROM? Will it die again? probably yes :-D Maybe there was some small tin residue on the PCB that I removed by spraying it: I noticed that the Chessmate had already been repaired before, there were visible signs on the pcb.

It will remain a mystery, anyway the MPS 6322 ROM can be replaced by a 2532 EPROM (pinout compatible) or by a 2732 EPROM with an adapter.

Gallery:

Regeneration of the Keyboard PAD.

Some keys did not work properly. The Keyboard PAD have been regenerated using a suitable product that can be found for sale on eBay. Try: KEYPAD FIX

Gallery of the fix:

The Home Computer Asem AM 100 is a clone of the Apple II+ (Apple // Plus). This computer was manufactured and assembled by ASEM S.p.A. Artegna (UD) / Italy.

The AM 100 is fully compatible with all the software available for the Apple II and II+. I have personally tested many programs and i’ve never found problems of compatibility.

Unfortunately this computer is arrived faulty, the repair was more simple than i expected, thanks to the IC sockets located on the computer motherboard.

Works that have been made:

• Replacing IC 74LS161 which shows a vertical band on the screen.
• Removing RIFA filter capacitor located inside the PSU.
• Regeneration of the Keyboard PAD. Some keys did not work properly. The Keyboard PAD have been regenerated using a suitable product that can be found for sale on eBay. Try: KEYPAD FIX
• General cleaning of the case outside/inside, monitor and keyboard.
• EPROM dump.

All these works are documented with photos that you can find below.

Gallery repairs:

12►

Under the cover gallery:

12►

Final photos:

Interesting discovery:

Inside the Floppy Drive reader (Apple clone) i have found the same mechanics (Mistumi / Newtronics) of the Commodore Floppy Drive 1541. See the first three pictures of the gallery: Under the cover.

Download: ASEM AM 100 full Eprom Dump (1437)

Replacing electrolytic capacitors Commodore Amiga 1200.

As you can see from the photos, the latest motherboard (Gallery full Recap Amiga 1200 #3) of Amiga 1200 suffered the classic problem of leaking capacitors.

Gallery full Recap Amiga 1200 #1:

Gallery full Recap Amiga 1200 #2:

Gallery full Recap Amiga 1200 #3:

Amiga 4000 badly Distorted Clipped Saturated audio Repair.

The problem is quite simple to find. You have to make some measurements on the integrated SMD LF347 (Op AMP) with the computer running and no sound.

You need to measuring pin 1 and pin 7 and should have a voltage of about 2.5V if the voltage as in my case (see photo) is  of 11.43v and 11.37v. Something is not working.

At this point you must also perform a new measurement on the pin 14 and pin 8, if also in this case it has a higher voltage of 2.5v evidently there is’ something that doesn’t work or with the LF347 or with the 750ohm resistor (R440 and R430).

The other three measurements to be done are the two input voltages, pin 4 should be about 12V and -12V on pin 11 approximately. In my case (see picture) are + 12.28v and -12.04v and are fine.

The third measurement is the Voltage Reference (Vref), this is very important, should not be less than 2v or greater than 3v. In my case (see photo) was 5.30v. This problem could be caused either by the circuit that provides the VRef (2 resistors and two capacitors) or just the same ic that creates problems with the Vref input.

In my case the failure was caused of the integrated SMD LF347 that i have replaced with a LM324. After replacing the voltages are back to normal, in the example photo you can see the Vref at 2.33v

The Amiga sound now works very well.

I have repaired several Commodore Amiga 4000 with the LF347 burned and from my personal experience can say that the acid leakage of capacitors C404, C433 and C443 make some short circuits on pins of the LF347 that obviously dies.

Audio before and after the repair:

• Amiga 4000 audio before the repair (1228)
• Amiga 4000 audio after the repair (1261)

Gallery:

Nothing of easier to put a socket for the oscillator to allow overclocking.

Gallery:

Yet another Commodore 64 repaired

Defect:

• White Flashing Screen then Black Screen.

Replace parts:

• 2 x 74LS257
• 1 x 6569 VIC-II

Note:

• After replacing the VIC-II (6569) the screen has stopped flashing but there was still some component broken.

I did this repair for a friend of mine after i heard that the new power supply cost 89.00 Euros !!

I have inserted a female RCA connector thus avoiding that the problem of “broken” cable happen again.

Gallery:

After the explosion of the filter capacitor (see video) i have removed the charred component.

Gallery:

Video:

The original Famicom (Japanese Nintendo) consoles are superior in design compared to the American/European NES.

One long forgotten feature is the extra sound channel, this extra channel was disconnected on US/EU console and removed from US/EU games. Castlevania 3 is a classic example. The original Japanese version has a much different theme song.

Below the photos of the fix to get the extra channel on the US/EU consoles.

Gallery:

source: krikzz.com

This gallery shows some stages of the repairing of the Floppy Drives of the Commodore SFD-1001 & Commodore CBM 8296D.

Defects found on the Floppy Drives:

• Floppy drives had the capacitors that leaked acid on the motor control pcb.

The difficulty was rebuild the tracks of the pcb and remove the most of the leaked acid of the capacitors. Unfortunately on the aesthetic level this type of repair are not perfect, but i’m glad that all drives now work.

To test the correct operation of the Floppy Drives i have used a working SFD-1001 with a ZoomFloppy Interface through the IEEE-488.

Replacing bad capacitors (Floppy Drive #1):

Replacing bad capacitors (Floppy Drive #2):

Replacing bad capacitors (Floppy Drive #3):

The reason of the replacement is the leaky capacitor.

The Aluminum Electrolytic Capacitors (SMD) used in these machines eventually exude their conductive contents onto the mainboard causing short circuits and corrosion of the pcb tracks.

Replacing the capacitors on an Apple Macintosh Classic II: