from 1541 Ultimate homepage:
Finally, you might think! An update on the 1541U-II… As time is going fast, the moment that all the hardware parts for the 1541U-II will be ready is drawing near. It all was not too easy, but things are going now the way they should.
The major difficulty showed to be the plastic case. Finally I have found a contractor who is willing to make the plastic case exactly as I wanted it, for a reasonable price. Unfortunately, the mould for plastic injection is quite expensive; in fact about double of what I expected initially, based on an unrealistic quote that I got a few months ago. Because of the large interest in the 1541U-II, I decided to just continue with it, and leave the selling price of the total product intact.

Earlier this week, I received the first pictures of the first try-outs  of the injection mould tool. The result shows a little problem in the  design, with the planned material (ABS). Due to the thick and sturdy  plastic constuction on the inside, sink marks are visible on the  outside.
The manufacturer has tried to run the case with a different  material (PA), which looks a lot better. However, due to different  shrinkage characteristics, the mould tool needs to be adapted to adjust  for the difference in material. (You can see this, that the matte  version does not close perfectly…) They will do this, but it will take  one week extra before the cases are ready. The final color won’t be  black (unless I am getting a lot of angry E-mails now.. ;-), but light  cream color, to match the C64C better.
 Read more…
			
		 
		
Recent Comments